硬镜和半硬镜的方法：

Disinfection method for hard and semi hard mirrors:

1、浸泡：2%戊二醛，25℃，60分钟。建议ETO气体：10%ETO（环氧乙烷）混合90%HCFC-124（氯四氟乙烷）气体，54±2℃,压力056～0.7Bar,2小时，通风干燥12小时，浓度600±30mg/L。

1. Soaking disinfection: 2% glutaraldehyde, 25 ℃, 60 minutes. Suggested ETO gas disinfection: 10% ETO (ethylene oxide) mixed with 90% HCFC-124 (chlorotetrafluoroethane) gas disinfection, 54 ± 2 ℃, pressure 056~0.7Bar, 2 hours, ventilation and drying for 12 hours, concentration 600 ± 30mg/L.

2、高温高压：建议尽量不要用高温高压，但在紧急时也可以进行高温高压。高温高压的条件：建议控制高温高压时间134°<5分钟121°<20分钟自然冷却。

2. High temperature and high pressure disinfection: It is recommended not to use high temperature and high pressure disinfection as much as possible, but high temperature and high pressure disinfection can also be carried out in emergency situations. Conditions for high-temperature and high-pressure disinfection: It is recommended to control the sterilization time of high-temperature and high-pressure disinfection by 134 °< 5 minutes 121 °< Free cooling for 20 minutes.

下面内窥镜设备维修厂家来讲讲内窥镜的一般注意事项：

Below are the general precautions for endoscopic equipment maintenance manufacturers:

1、在清洗和的时候，建议把镜子和别的手术器械分开，用塑料盆清洗。

1. When cleaning and disinfecting, it is recommended to separate the mirror from other surgical instruments and use a plastic basin for cleaning.

2、前要把镜头清洗干净，否则异物在后积累在镜头上，以影响图像质量。当镜头上异物过多时，可用棉签涂一些镜子附带的清洁剂在镜面上，然后用清水清洗干净。

2. Before disinfection, the lens should be cleaned thoroughly, otherwise foreign objects will accumulate on the lens after disinfection, which may affect image quality. When there are too many foreign objects on the lens, you can use a cotton swab to apply some of the cleaning agent that comes with the mirror to the mirror surface, and then clean it with clean water.

3、尽量不要频繁更换方法，这样对镜子的密封有好处。

3. Try not to frequently change the disinfection and sterilization methods, as this is beneficial for the sealing of the mirror.

4、禁止用超声波清洗镜子，尽量不要用生理盐水清洗镜子，否则容易生锈迹。

4. It is prohibited to use ultrasound to clean mirrors, and it is recommended not to use physiological saline to clean mirrors, as this may cause rust.

5、当高温高压完镜子后，一定要让镜子自然冷却，禁止用冷水冷却。

5. When the mirror is sterilized under high temperature and pressure, it must be Free cooling. It is forbidden to use cold water for cooling.

6、所以的镜子浸泡时间不能超过60分钟。

6. The soaking and disinfection time of all mirrors should not exceed 60 minutes.

硬镜和半硬镜的方法以及一些注意事项就讲解到这里了，还有什么问题就来我们网站http://www.jiangrenyiliao.cn咨询吧！

That's all for the disinfection methods and some precautions for hard and semi hard mirrors. If you have any further questions, please come to our website http://www.jiangrenyiliao.cn Consult!